The state of the art Class D digital amplifier designed for the CORE series
active cabinets sets a new industry benchmark in audio performance, efficiency
and flexibility. The class D amplifiers were specifically designed to power not
only the active loudspeaker that it is built-into but it is specifically
designed to drive its corresponding passive cabinet. This is made possible by
integrating a parallel speaker output connector to an extremely powerful,
efficient & reliable Class D amplifier. This simple yet innovative concept
design can save users up to more than 50% on the upfront cost an active line
array system and as a bonus, lowers the total systems overall weight.
The CORE 8218SA is an 18”
active subwoofer system. The CORE 8218SA features a one channel, 1500W, Class D
amplifier that is specifically designed to power its corresponding passive
cabinet, the CORE 8218SP, but can be used in a full active line array setup if
required or preferred. The CORE 8218SA is compact, lightweight and can be flown
or ground stacked and possesses high output capability with low frequency
extension. It contains a single Ultra-long 18” / 4” V.C. woofer is front loaded
and the rear of the low frequency driver is reflex loaded to extend the Low
frequency output to below the natural cut off point. The proprietary rigging
system of the CORE8218SA is directly compatible with the CORE 82A, CORE 82P ad
CORE 8218SP. Each enclosure is constructed with a threaded pole-mount socket on
the top of each cabinet for use with the CORE82-BPSYS pole-mount and bracket
system. The CORE 8218SA also features the latest digital signal processor and
the NUCLEUS FIR loudspeaker managment software.
Nucleus FIR is a loudspeaker management software providing all of the features and flexibility required to drive and align the CORE series sound reinforcement systems. Incorporating traditional IIR X-over and parametric EQ functions in conjunction with revolutionary FIR modes, Nucleus FIR is one of the most flexible, advanced yet user friendly loudspeaker management software in the world. The NUCLEUS FIR software and integrated applications transforms the CORE series sound reinforcement system from an active line array system into a transcendent and revolutionary piece of audio technology no professional should be without.
Amplification and Processing
series amplifiers offer a full set of value added features such as:
series active cabinets amplifier compact modules
ranging from 1000W (CORE82A), 1500W(All
Subwoofers) and 1600W (CORE102A).
to Class-D technology, the CORE series amplifier
modules deliver unmatched audio specifications
in the pro audio industry including the
modules with the highest dynamic range and the
lowest distortion in the pro audio industry.
Series amplifier’s provides universal mains operation
for 120 V and 230 V. The power supply is regulated
to deliver consistent power world-wide.
Series amplifier modules are fully self-protected.
All relevant protection features have been
implemented individually for the SMPS and for each
amplifier channel including efficient heat dissipation
system, integrated cooling fans and Over-Heat
protection.Moreover the Clip/Limiter function
provides output monitoring to prevent speaker
damage with gentle gain reduction at clip threshold.
Approved - EMC Complaint
approved and verified for EMC compliance.
for DSP / Network
addition to the conventional readouts and
power, CORE modules offer advanced real
readouts for fully interfacing to the NUCLEUS
and network solutions. Sophisticated
processor with a powerful 96 kHz 24
DSP Engine and high performance 24bit AD/DA
are also included.
Approved - EMC Complaint
board DSP and RS485 connection for monitoring
control via the state of the art NUCLEUS FIR
All setup parameters
for input mixing, DSP features and the
setting are accessible by using the NUCLEUS
Gate, crossover filters, parametric EQs per input
output sections, RMS compressor, alignment delay
All-Pass filters, everything needed to optimize a
& Noise Generator
with a Dynamic Loudness function and a Pink