The state of the art Class D digital amplifier designed for the CORE series active cabinets sets a new industry benchmark in audio performance, efficiency and flexibility. The class D amplifiers were specifically designed to power not only the active loudspeaker that it is built-into but it is specifically designed to drive its corresponding passive cabinet. This is made possible by integrating a parallel speaker output connector to an extremely powerful, efficient & reliable Class D amplifier. This simple yet innovative concept design can save users up to more than 50% on the upfront cost an active line array system and as a bonus, lowers the total systems overall weight.
The CORE 10218SP is a passive 18" sub-bass system specifically designed to be used with the CORE 10218SA active sub-bass cabinet but can be used in a fully passive setup with rack-mount amplifiers if required or preferred. The CORE 10218SP is compact, lightweight and can be flown or ground stacked and possesses high output capability with low frequency extension. It contains a single Ultra-long 18” / 4” V.C. woofer is front loaded and the rear of the low frequency driver is reflex loaded to extend the Low frequency output to below the natural cut off point. The proprietary rigging system of the CORE10218SP is directly compatible with the CORE 102A, CORE 102P ad CORE 10218SA.
Nucleus FIR is a
loudspeaker management software providing all of the features and flexibility
required to drive and align the CORE series sound reinforcement systems.
Incorporating traditional IIR X-over and parametric EQ functions in conjunction
with revolutionary FIR modes, Nucleus FIR is one of the most flexible, advanced
yet user friendly loudspeaker management software in the world. The NUCLEUS FIR
software and integrated applications transforms the CORE series sound
reinforcement system from an active line array system into a transcendent and
revolutionary piece of audio technology no professional should be without.
Amplification and Processing
CORE series amplifiers offer a full set of value added features such as:
Ultra High Power
CORE series active cabinets amplifier compact modules ranging from 1000W (CORE82A), 1500W(All Subwoofers) and 1600W (CORE102A).
Unmatched Audio Specifications
Thanks to Class-D technology, the CORE series amplifier modules deliver unmatched audio specifications in the pro audio industry including the modules with the highest dynamic range and the lowest distortion in the pro audio industry.
CORE Series amplifier’s provides universal mains operation for 120 V and 230 V. The power supply is regulated to deliver consistent power world-wide.
CORE Series amplifier modules are fully self-protected. All relevant protection features have been implemented individually for the SMPS and for each amplifier channel including efficient heat dissipation system, integrated cooling fans and Over-Heat protection.Moreover the Clip/Limiter function provides output monitoring to prevent speaker damage with gentle gain reduction at clip threshold.
Safety Approved - EMC Complaint
Safety approved and verified for EMC compliance.
Readouts for DSP / Network
In addition to the conventional readouts and auxiliary power, CORE modules offer advanced real time readouts for fully interfacing to the NUCLEUS FIR and network solutions. Sophisticated loudspeaker processor with a powerful 96 kHz 24 bit DSP Engine and high performance 24bit AD/DA converters are also included.
Safety Approved - EMC Complaint
On board DSP and RS485 connection for monitoring and control via the state of the art NUCLEUS FIR loudspeaker management software. All setup parameters for input mixing, DSP features and the limiter setting are accessible by using the NUCLEUS FIR software.
Noise Gate, crossover filters, parametric EQs per input and output sections, RMS compressor, alignment delay and All-Pass filters, everything needed to optimize a self-powered loudspeaker.
Loudness & Noise Generator
Equipped with a Dynamic Loudness function and a Pink /White noise generator.